Some advice from locostbuilders (and Marc)

Quick post before we head into the garage for the day - advice from some of the other MNR builders on locostbuilders said that we'd need to support the bodywork at thr front, higher than the mounting points currently are. Marc confirmed that they had to do this on slightly older bits of bodywork. Also a possibility is flattening down the rivet that the bottom piece is catching on, and thinning the ali plate on the bottom there (two pieces overlap just under where the body pops out). Hopefully we can get this bit cracked today, and finish off the locating holes for the suspension. Then it can all come off again! :)